Micro-Optik offers motorized high precision stands for all possible applications.

Illumination is integrated in accordance with customer requirements.

Standard we provide stands with back light illumination.

Base width ranging from 40 mm to 225 mm.
Travels range from 15 mm to 5500 mm. Our versatile, modular design yields easy XYZ-rotary combinations.

Coeicient of friction: 0.09 typical
Coeicient range: 0.04.
Repeatability: 5 microns .
Straight line accuracy: 8 microns over entire travel distance.
Screw lead accuracy: 0.076 mm/25 cm.
More accurate assemble available on
demand.

Higher strength to weight ratio – uses hard aluminum alloys and a rigid I-beam cross section.

Resistant to impact loads
Natural wiping action expels debris.
Gradual wear not sudden failure of rolling element type screws and guide-ways.

Corrosion resistant anodized inish.
Operate without lubrication.
Spare set of guide-ways built-in on the lip side just in case the primary ones get damaged.

Dynamic Microstepping uses low cost of-the-shelf 8 bit microprocessors to achieve high level of microstepping (any microstep value from 2 to 500) and pulse rate support (800Kbps).

Dynamic Coniguration uses
Pulse/Dir/Enable/Alarm signals to control and to conigure the microstep driver. No more switches, potentiometers or extra communication ports, resulting in cost and space savings.

Diferent types of interfaces - Ethernet, RS-485, and USB 2.0 based motion products to meet your network motion control needs.

In addition to providing standard motion products, our team of engineers is ready to meet your individual needs through custom engineering.

Look for some other models here or download the DIMIC system flyer.